Doubling linework from templates on 2D plan view

I am dropping templates in my 2D file which contains my alignment and 2D plan view geometry.  When I do this, the templates draw a 2nd set of lines active in my file associated with that template.  This gets very confusing as now I have 2 sets of overlapping lines(2D design + template lines).  Is there a setting that turns off template linework in my 2d view? Or some other method to get these line to not clutter up the 2D view? 

I am using

• GEOPAK SS4 08.11.09.845
• Microstation SS3 08.11.09.714

Thank you,

Michael