All structures are displaying correctly. All structures are along the same alignment, they were created by network, so the alignment should be down the centerline of the pipe run.
My sdb, and related files are here: 1drv.ms/.../s!AjtiAOKOjuoRlpB1vP6s6lRQx_BqwA
I have HGL and EGL checked in the create profile dialog. I'm using the "Profile Sheets 60:1" preference from the xin file located at the link above for creating the profiles.
I have had a problem like this in the past where I have split flow and hadn't entered a user defined head loss, but that does not apply here. and like I mentioned, the HGL is calculating, just not display in all cases. Even simple runs with two pipes and two inlets won't display correctly (for example P 11-01 to CB 11-02 in my uploaded SDB)
My sdb, and related files are here: 1drv.ms/.../s!AjtiAOKOjuoRlpB1vP6s6lRQx_BqwA
I have HGL and EGL checked in the create profile dialog. I'm using the "Profile Sheets 60:1" preference from the xin file located at the link above for creating the profiles.
I have had a problem like this in the past where I have split flow and hadn't entered a user defined head loss, but that does not apply here. and like I mentioned, the HGL is calculating, just not display in all cases. Even simple runs with two pipes and two inlets won't display correctly (for example P 11-01 to CB 11-02 in my uploaded SDB)