Quantcast
Channel: OpenRoads | OpenSite Forum - Recent Threads
Viewing all articles
Browse latest Browse all 15087

RE: using point control causing template origin to shift

$
0
0
Ryan, are you sure your cross sections are cut at the same increment / interval as your modeling? (or at least a function of the modeling interval?) The areas between 'modeled' locations are interpolated and would give you this 'offset' along any curves. On a tangent it should be dead on. ...and have you checked the 0,0 of your template origin in the ITL to make sure there wasn't some slight offset on the Dynamic Origin when the template was initially constructed?

Viewing all articles
Browse latest Browse all 15087

Trending Articles