Hey everyone. I am new to Site Modeler and am trying to create an approximately one percent sloped surface draining from right to left (east to west) within the red element shown. The green ellipse is my target destination for drainage which has an elevation of 2832.5. The red boundary is important because there are paved roads to the north and east of the boundary, and railroad to the south.
Once I have a sloped lot created approximately where the red element is, I am going to create building pads where the blue rectangles are. At this point, I do believe once I have the lot created that creating the pads with a 1'0" offset will be no problem - I am able to do it, but am unable to adjust the slope away from the pads - which would be nice to know how to do as a part of this.
Any help is appreciated. I have been at this for weeks and my brain is turning to mush. Let me know if I should provide any other information as well.
Thank you in advance!