Has anyone had issues with the Automatic Subarea Delineation tool causing GEOPAK to continually crash?
When I initially set up my drainage network I used Automatic Delineation tool for Subareas and it worked well, but while modifying the network it was causing me issues. Every time I would run the computations to design my network GEOPAK Drainage would crash and it would give me the error "System fault : bad memory access". I noticed that this would happen while the program was delineating Subareas. My workaround to get the GEOPAK Drainage file to compute the network again was to enter the Subarea information by hand. Has anyone else had this problem?
Thank you
