I am trying to tighten up the spacing in my Cross Section Sheets by adjusting the Vertical Range, Lower and Upper Limit. When I leave the Lower Limit set to 0, and set the Upper Limit to 50, it will skip plotting a section every 500 feet, 360+00, 365+00, 370+00, etc. It will still attach the cross section reference, and label the station, but you don't see any part of the cross section. If I set the lower limit to a 1 foot, it will plot the all of the sections, but I am still not reducing the space between the sections, and not reducing the number of Cross Section Sheets.
Any suggestions??