Jake, How is the point 3:1..(its hard to read) constrained?. You should have a "Vector Offset" from that point to the FG_RSU_L point. This will assure the component follows the fill slope. Additionally, I would "Insert" a point on the fill slope and place it on the 3:1 point and then "Merge" the two points together. This will tie-down the point to the fill slope
I see you are in Albany, NY. I was born and raised there and worked for CHA for 25 years.
I see you are in Albany, NY. I was born and raised there and worked for CHA for 25 years.