To do this you will to need to construct two end conditions.
The first is from the origin to Point 1 to Point 2.
The second is from Point 2 to Point 3 to Point 4.
Point 1 is vertically and horizontally offset from the origin.
Point 2 is vertically and horizontally offset from Point 1. All four boxes are checked under End Condition Properties.
Point 3 is sloped and horizontally offset from Point 2. Nothing is checked under End Condition Properties.
Point 4 is sloped and horizontally offset from Point 3. Check these: Check for Interception, Place Point at Interception, End Condition is Infinite.
I tested it and produced the below...
Hopefully this will get you started