Thomas, I see that this question had been posted back in September 2016.
We have a team of approx. 17 BIM professionals on a high-profile job that are very much depending on productivity enhancements, that hopefully make Bentley competitive with Autodesk. We made an executive decision to use Bentley products at the beginning of the job, and now I am slowly losing the balance, as more and more upcoming project members , knowing Autodesk product from their previous jb placement are switching to it; Autodesk perfected interoperability, and there are plenty of youtube videos that anyone can pick up and learn , whereas I cannot supply adequate answer to these basic questions ( such as IFC export), that Autodesk already figured out long time ago. Please, make sure you are catching up and then some.
Thank you four attention.
We have a team of approx. 17 BIM professionals on a high-profile job that are very much depending on productivity enhancements, that hopefully make Bentley competitive with Autodesk. We made an executive decision to use Bentley products at the beginning of the job, and now I am slowly losing the balance, as more and more upcoming project members , knowing Autodesk product from their previous jb placement are switching to it; Autodesk perfected interoperability, and there are plenty of youtube videos that anyone can pick up and learn , whereas I cannot supply adequate answer to these basic questions ( such as IFC export), that Autodesk already figured out long time ago. Please, make sure you are catching up and then some.
Thank you four attention.