Hello,
I am attempting to create a model of a Median barrier, which contains a number of rules that determine the type of barrier to be constructed.
The design levels of each carriageway differs, so the barrier type changes to suit (50mm increment in height).
To create 'true' barrier components (6m length), I have placed template drops at 6m intervals. Where each length falls within one of the criterion (rules), all is well, however when the barrier falls within several criterion (say the 50 and 100mm zones) no components are created. I am trying to figure out how a 'transition component' might look (current thinking is if values are between 2 zones, AND standard zone components are NOT displayed then place transition component (I will drive the transition values based on vertical controls).
Any assistance would be greatly appreciated.
Cheers
Rob
(InRoads SS2)