I too noticed that the XS_TL_CL feature had Create Template Geometry set to false, so I adjusted it to true and tried again. After I did that and synchronized my templates and processed the corridor, it worked. But, I tried to run the cross sections again as i had changed some areas, and now it doesn't work again. I checked the feature and it is still set to True. And like you mentioned, the EOS was set to false and it is still working, so it doesn't look like that does anything.
I'm not sure what you mean by are my CL points construction or primary. The point in the template is using the feature definition of XS_TL_CL. I browsed through that definition and there is nothing about the class. I'm not sure what to check beyond that.
Until I get any other information, I will go back to trial and error to see what works. Hopefully I can get something to work again.
I'm not sure what you mean by are my CL points construction or primary. The point in the template is using the feature definition of XS_TL_CL. I browsed through that definition and there is nothing about the class. I'm not sure what to check beyond that.
Until I get any other information, I will go back to trial and error to see what works. Hopefully I can get something to work again.