thanks for the reply Nico, but not sure I explained my problem well. Let me try again..
The designer I'm working with wants to place the clip shapes for each alignment into a different model of the microstation file. RampA clip shapes would be placed into microstation model "Ramp A". Ramp B clip shapes would be placed into Microstation model "Ramp B". etc...
Again, seems I can do this without any problem back in Geopak ss2. But, in Geopak ss4, I get an error message that reappears that I have to "OK" through multiple times (the error reappears over and over). In fact the error repeats the EXACT number of times that represent the other clip shapes in the other microstation models that aren't active. So, if model Ramp A has 5 clip shapes and model Ramp B has 7 clip shapes, I'll get the error 12 times when I try to create clip shapes into model Ramp C.
The designer I'm working with wants to place the clip shapes for each alignment into a different model of the microstation file. RampA clip shapes would be placed into microstation model "Ramp A". Ramp B clip shapes would be placed into Microstation model "Ramp B". etc...
Again, seems I can do this without any problem back in Geopak ss2. But, in Geopak ss4, I get an error message that reappears that I have to "OK" through multiple times (the error reappears over and over). In fact the error repeats the EXACT number of times that represent the other clip shapes in the other microstation models that aren't active. So, if model Ramp A has 5 clip shapes and model Ramp B has 7 clip shapes, I'll get the error 12 times when I try to create clip shapes into model Ramp C.
