I have a looping alignment that I needed for point controls. However, since it loops, the software got confused as to which crossing point to use. So I tried to split it and now have two derived alignments from the original.
Now, I need to move the split point but cannot figure out how to accomplish this.
- I cannot seem to export the alignment only the original looping alignment exports.
- When I select one of the two derived alignments, it shows me the "apparent" endpoints of either half, but none of the handles seem to move the split point.
- None of the regular MicroStation tools seem to what to allow that manipulation.
I really need the horizontal Element tools in Open Roads!
Any suggestions would be greatly appreciated.