RE: Display reference string chainage in MXROAD dynamic sections

Hi Chris,

I can't get this NOT to work.

I pick a Design and ground model, go in to Dynamic Sections and set up a set of sections from chainage 270 to 540. The actual alignment is from 0-2000.
When in the Dynamic Section viewer, the scroll bar along the bottom is from chainage 270 to 540. I've tried it a few times with different chainage ranges, and also by doing the whole length first off, and it always puts the correct value in the scroll bar.

I'm happy to look at your data, you can send it to me simon.pegg@bentley.com

Thanks

Simon

Bentley Civil Support